Altana Byko-Test MP0R Manual do Utilizador descarregar pdf (Página 20)

3. Perform three to five measurements on the uncoated specimen.

The current reading appears on the display after each measurement.

4. Press button [OK].

Note: When pressing [OK], the mean value of all measurements is used as the normalization value.

This mean value is set to 0. The display shows 0.00.

STD1 (that is, calibration standard # 1) appears on the display.

5. Measure at least two times on the uncoated specimen. A reading will appear.

6. Use button [] or [] to set the displayed value to 0.00.

7. Press button [OK]. The baseline of the characteristic is restored.

Ready. The instrument is again ready to measure, but you must do a corrective calibration prior to measuring.

Cf. Chapter

8 Calibration.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Sem comentários

Altana Byko-Test MP0R Manual do Utilizador Página 20